Skip to content

PD-03-458ECMA-A55.10.03.01

Glued top, snap-lock bottom carton (bottom on panel 3)

ECMA A55.10.03.01. Top: four flaps glued shut on the line - full overlap (ECMA 10), or one full flap over three reduced ones (ECMA 11), chosen in the settings. Bottom: a glue-free 1-2-3 snap-lock base closed by hand: two wings and a locking panel that hooks between them. The bottom closure hangs from panel 3. Panels are counted from the glue joint, as the ECMA code counts them: panel 1 carries the joint and panel 3 is opposite it. The same die is also ECMA A55.10.03.03, A55.11.03.01, A55.11.03.03: the glued end's flap form (full overlap 10 or reduced flaps 11) and the panel of its outer flap are settings.

Drawing…
CutCreaseGlue area
Flat blank
—
Rule length
—
Area
—
Panels
—

Size & options

Dimensions
mm

Between 15 and 1,200

mm

Between 10 and 1,200

mm

Between 15 and 1,600

Flaps & tabs
mm

Between 0 and 80

Full overlap: the inner and outer flaps both reach across the end and are glued face to face. Reduced flaps: only the outer flap reaches across; the other three are cut short and it is glued down onto them.

Which panel the flap that comes down last hangs from, counted from the glue joint as the ECMA code counts. It decides which face shows the glue line, so it follows the print.

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 40

mm

Between 0 and 40

mm

Between 0.5 and 30

Production

Which hand the joint is on. It follows the gluer the job is booked on, and it mirrors the whole blank.

mm

Between 0.1 and 12

Features
deg

Between 25 and 65

mm

Between 2 and 200

mm

Between 3 and 120

mm

Between 0 and 600

mm

Between 0 and 400

Advanced settings+
mm

Between 0 and 30

mm

Between 0 and 20

mm

Between 0 and 30

mm

Between 0 and 12

mm

Between 0 and 20

mm

Between 0 and 20

mm

Between 0 and 30

Order this box
Request a quote

Our structural designers review the final dieline before production.