Skip to content

PD-02-007ECMA-A10.21.01.03

Hang-tab tuck top, glued bottom carton (top on panel 3)

ECMA A10.21.01.03. Top: a tuck lid with dust flaps, the back panel running on past the end into a hang tab with a euro slot for a peg hook. Bottom: four flaps glued shut on the line - full overlap (ECMA 10), or one full flap over three reduced ones (ECMA 11), chosen in the settings. The top closure hangs from panel 3. Panels are counted from the glue joint, as the ECMA code counts them: panel 1 carries the joint and panel 3 is opposite it. The same die is also ECMA A10.21.03.03, A11.21.01.03, A11.21.03.03: the glued end's flap form (full overlap 10 or reduced flaps 11) and the panel of its outer flap are settings.

Drawing…
CutCreaseGlue area
Flat blank
—
Rule length
—
Area
—
Panels
—

Size & options

Dimensions
mm

Between 15 and 1,200

mm

Between 10 and 1,200

mm

Between 15 and 1,600

Flaps & tabs
mm

Between 0 and 80

mm

Between 0 and 1,200

mm

Between 0 and 200

mm

Between 0 and 30

mm

Between 0 and 25

mm

Between 0 and 400

mm

Between 0 and 20

Friction lock: the tongue's shoulders ride over the dust flaps and hold by friction. Slit lock: two slits on the tuck crease make the tongue's corners catch, so the end has to be pressed to open.

Full overlap: the inner and outer flaps both reach across the end and are glued face to face. Reduced flaps: only the outer flap reaches across; the other three are cut short and it is glued down onto them.

Which panel the flap that comes down last hangs from, counted from the glue joint as the ECMA code counts. It decides which face shows the glue line, so it follows the print.

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 40

mm

Between 0 and 40

mm

Between 0.5 and 30

Production

Which hand the joint is on. It follows the gluer the job is booked on, and it mirrors the whole blank.

mm

Between 0.1 and 12

Features
mm

Between 18 and 200

mm

Between 0 and 40

Advanced settings+
mm

Between 0 and 30

mm

Between 0 and 6

mm

Between 0 and 12

mm

Between 20 and 90

mm

Between 0 and 20

mm

Between 0 and 20

mm

Between 0 and 30

Order this box
Request a quote

Our structural designers review the final dieline before production.