Skip to content

PD-02-004ECMA-A01.10.00.01

Glued top, open bottom carton

ECMA A01.10.00.01. Top: four flaps glued shut on the line - full overlap (ECMA 10), or one full flap over three reduced ones (ECMA 11), chosen in the settings. Bottom: open, with no flaps - for a sleeve, a display, or a carton that slides into a tray or an outer. The same die is also ECMA A01.10.00.03, A01.11.00.01, A01.11.00.03, A10.01.01.00, A10.01.03.00, A11.01.01.00, A11.01.03.00: the glued end's flap form (full overlap 10 or reduced flaps 11) and the panel of its outer flap are settings; turned end over end, with the glue joint on the other hand, it is the carton filled from its other end.

Drawing…
CutCreaseGlue area
Flat blank
—
Rule length
—
Area
—
Panels
—

Size & options

Dimensions
mm

Between 15 and 1,200

mm

Between 10 and 1,200

mm

Between 15 and 1,600

Flaps & tabs
mm

Between 0 and 80

Full overlap: the inner and outer flaps both reach across the end and are glued face to face. Reduced flaps: only the outer flap reaches across; the other three are cut short and it is glued down onto them.

Which panel the flap that comes down last hangs from, counted from the glue joint as the ECMA code counts. It decides which face shows the glue line, so it follows the print.

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 400

mm

Between 0 and 40

mm

Between 0 and 40

mm

Between 0.5 and 30

Production

Which hand the joint is on. It follows the gluer the job is booked on, and it mirrors the whole blank.

mm

Between 0.1 and 12

Features
Advanced settings+
mm

Between 0 and 30

mm

Between 0 and 20

mm

Between 0 and 20

mm

Between 0 and 30

Order this box
Request a quote

Our structural designers review the final dieline before production.